Recent content by Ishay

Try to Restore to default And Install a fresh new firmware through DJI assistant 2.

Ok, so I found the problem. My friend has a spark with a dead MB and Gimbel so I did the switch and the spark is now working flawlessly which concludes that It must be a faulty motor or ESC. Thanks everybody for the help!

That’s just one of the logs, tried waiting to get a good GPS signal and it still behaves the same. Actually the RTH and AutoLand works just fine.

I have 4 batteries and it happens on all. Where did you upload it to see the voltages?

Thanks but Tried that as well with or without SD card

Mine used to do it occasionally but now it does it almost every single time no matter how I take off.

Tried that a few times with older and newer versions. Tried calibrating everything. I’m pretty sure it’s a hardware issue. If I could only find the faulty hardware I’ll change it myself.

Flight log added sigondroner

I have a lot of propellers and I tried them all so it’s not that.

Exactly the same! I saw in a post that it might be motor related problem but I couldn’t find something wrong with the motors.

It’s not a new place. I got the logs from the black box tab in the DJI assistant 2 and I could not open them. I’ll upload them when I get home.

Hi all, When I try to takeoff, my spark goes up as usual but when I push the throttle it has a hard time pulling up and ends up bouncing on the ground. Needless to say I broke a few propeller and some new scratches to the spark's body. I've been having this issue since day but it happened...

Great to hear! Then I’d probably leave it like that. Thanks :)

leaving this link in case someone needs this part replaced. https://www.ebay.com/itm/123754197180

I meant to ask if you can make contact between the gimble and the bumper not the spark body. sorry for the confusion. thanks