Recent content by dji_chao

Hi, I was reading some of the DJI components. I was thinking of assemble some drone system myself. Reading through SNAIL spec, I did not see much about pin connections. I roughly know one side is 3 pins to the motor, and the other side is GND/VDD, with two additional wires. Flight controller...

Hi jimlips, I am intending to use the ESC+motor (DJI spark parts) purchased, and build my own flight controller (using FPGA) to drive the ESC. If you can google or search a bit for ESC, the board has 6 pins A/B/C (to the motor), +/- (from flight controller board VDD/VSS), TX (from from flight...

I am an electronics hobbyist. My intention is to drive TX of ESC chip myself. Currently I have a few hardware below 1) DJI Spark Brushless Motor 1504s 2) ESC Board for DJI Spark Part 3) Some FPGA development board. I can build hardware or build some MCU system to write some firmware code. I...