Recent content by Tribar

What does the recorded (original) footage on the SD-card look like? Does it show the same issue? Perhaps this is only a bug/issue in the xRecorder app.

Litchi is available from Amazon for the CS !

The latest DJI app (DJI FLY) used by the Mavic Mini and Mavic Air 2, and I'm sure any future DJI Drones, is NOT compatible with the CS. It (DJI FLY) will be available for the Smart Controller.

The Xiaomi Mi Wifi Repeater 2 seems to work well with the DJI Tello.

It's NOT the GO4 app that has a fairly pathetic range, it's the smart device's wifi strength. Dronelink is a system (app) primarily for flying automated missions (waypoint missions). During such a flight all kinds of calculations have to made on the fly to controll the hight, speed, direction...

Most likely magnetic interference and/or compass not calibrated.

There's no benefit in upscaling footage.

The Spark has to be in the air in order for Quickshots to work.

I'm sure it doesn't fit your spark.

https://lumecube.com/products/strobe

That's exactly what it is.

Try: 1. Put SD-card back in drone. Turn drone ON, wait a few seconds, turn drone OFF again. if this did not work: 2. Fix-DJI 4.1.0.0 Free Download - VideoHelp

While flying indoors it probebly did not have a GPS-fix yet, so it didn't know where it was on the planet. As soon as it did get a GPS-fix it knew it's position and was in a NFZ. Yes, the NFZ-database is stored in the drone itself.

When disconnected: gimbal-interpolation does NOT work. It stays at the last calculated angle until connected again.

The Samsung Tab E dates from 2015 hand has very low specs: Quad core, 1.5GB ram and 8GB storage. When I bought my first drone in 2015 the DJI GO app at that time ran on my Samsung galaxy S3 phone. After a year constantly updating to the newest DJI GO app the S3 was NOT supported anymore, specs...