Menu
Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Search
Search titles only
By:
Search titles only
By:
Menu
Welcome DJI Spark Pilot!
Jump in and join our free Spark community today!
Sign up
Forums
DJI Spark Forums
Spark Discussions
I don't trust spark
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="SlowSL" data-source="post: 90535" data-attributes="member: 17142"><p>I may have also spoken too soon. Last week I took a flight, and while flying forward, no yaw or roll, and relatively close range, no obstructions, I had a complete signal loss for 11 seconds. The AC initiated a RTH. Once I regained a signal, I tried to cancel RTH three times, all unsuccessfully, it just kept on coming home. About 8 seconds later, a yaw error occurred, and it just sat there in ATTI mode. I was finally able to take control of it at this point and continue traveling back, and eventually, it switched back to P-GPS. 2nd flight, while moving from hovering to forward flight, 8 seconds later, it again received a yaw error and switched to ATTI mode. This was hundreds of feet of altitude, I don't know where magnetic interference would occur. Had I not been able to reconnect during the 1st flight, I would be out looking for the downed Spark. I fly fine in ATTI mode, but my worry is losing the signal and getting a yaw error at the same time. This also puts a damper on Litchi missions that are close to or beyond RC range. After some searching the forums, yaw errors seem to be a problem with the Spark.</p></blockquote><p></p>
[QUOTE="SlowSL, post: 90535, member: 17142"] I may have also spoken too soon. Last week I took a flight, and while flying forward, no yaw or roll, and relatively close range, no obstructions, I had a complete signal loss for 11 seconds. The AC initiated a RTH. Once I regained a signal, I tried to cancel RTH three times, all unsuccessfully, it just kept on coming home. About 8 seconds later, a yaw error occurred, and it just sat there in ATTI mode. I was finally able to take control of it at this point and continue traveling back, and eventually, it switched back to P-GPS. 2nd flight, while moving from hovering to forward flight, 8 seconds later, it again received a yaw error and switched to ATTI mode. This was hundreds of feet of altitude, I don't know where magnetic interference would occur. Had I not been able to reconnect during the 1st flight, I would be out looking for the downed Spark. I fly fine in ATTI mode, but my worry is losing the signal and getting a yaw error at the same time. This also puts a damper on Litchi missions that are close to or beyond RC range. After some searching the forums, yaw errors seem to be a problem with the Spark. [/QUOTE]
Verification
Post reply
Forums
DJI Spark Forums
Spark Discussions
I don't trust spark