Menu
Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Search
Search titles only
By:
Search titles only
By:
Menu
Welcome DJI Spark Pilot!
Jump in and join our free Spark community today!
Sign up
Forums
DJI Spark Forums
Spark Discussions
Lost light cap on back propellor
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Pashasdad" data-source="post: 6198" data-attributes="member: 651"><p>I had read on the DJI Spark forum that they (DJI) recommend putting a few small drops of adhesive on the LED covers to prevent them from popping off. I lost three of them in an errant crash in which DJI replaced my Spark.</p><p>I used UV curable adhesive in three different areas around each of the rims where they snap in to the arms of my replacement Spark just to be safe.</p><p>May want to try it, just be sparing with the adhesive. UV cureable adhesive is good because it cures immediately after applying UV light for about 30-45 sec. I used a very small dot, some ran in to the small gap and may hold it well.</p><p></p><p>Here's a link to some good UV adhesive on Amazon:</p><p><a href="https://www.amazon.com/Bondic-Anything-Waterproof-Resistant-Plastic/dp/B00QU5M4MG/ref=sr_1_1?ie=UTF8&qid=1500341465&sr=8-1&keywords=glue+with+uv+light" target="_blank">Amazon.com: Bondic,Repair Anything! Better Than Glue! Waterproof, Heat Resistant, Made In USA! Up To 100 Fixes! The 1st Liquid Plastic Welder! Bond, Build, Fix & Fill Anything In Seconds! (Bondic Starter Kit): Arts, Crafts & Sewing</a></p></blockquote><p></p>
[QUOTE="Pashasdad, post: 6198, member: 651"] I had read on the DJI Spark forum that they (DJI) recommend putting a few small drops of adhesive on the LED covers to prevent them from popping off. I lost three of them in an errant crash in which DJI replaced my Spark. I used UV curable adhesive in three different areas around each of the rims where they snap in to the arms of my replacement Spark just to be safe. May want to try it, just be sparing with the adhesive. UV cureable adhesive is good because it cures immediately after applying UV light for about 30-45 sec. I used a very small dot, some ran in to the small gap and may hold it well. Here's a link to some good UV adhesive on Amazon: [URL="https://www.amazon.com/Bondic-Anything-Waterproof-Resistant-Plastic/dp/B00QU5M4MG/ref=sr_1_1?ie=UTF8&qid=1500341465&sr=8-1&keywords=glue+with+uv+light"]Amazon.com: Bondic,Repair Anything! Better Than Glue! Waterproof, Heat Resistant, Made In USA! Up To 100 Fixes! The 1st Liquid Plastic Welder! Bond, Build, Fix & Fill Anything In Seconds! (Bondic Starter Kit): Arts, Crafts & Sewing[/URL] [/QUOTE]
Verification
Post reply
Forums
DJI Spark Forums
Spark Discussions
Lost light cap on back propellor