Menu
Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Search
Search titles only
By:
Search titles only
By:
Menu
Welcome DJI Spark Pilot!
Jump in and join our free Spark community today!
Sign up
Forums
DJI Spark Forums
Spark Discussions
No channel bars???
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Giantprawn60" data-source="post: 80847" data-attributes="member: 15632"><p>So i had this issue where i had no channel bars showing at all.Drone would fly fine though.It only said i was on 5.8ghz.Nothing else and i couldn't change it. I was using OTG or WIFI only and i had no channels showing in both cases.Well I found the fix in my case.I use a Nvidia Shield tablet. I had to untick the "location" icon in the notification bar at the top(i believe it's the same as the GPS icon on other devices). Then I power on the Spark, then RC. I connect the Nvidia to the RC through its wifi signal and open DJI Go 4. It connects. I go in the WIFI settings and waited about 5-10 secs.And voila, the channel bars appear!! I <u>then</u> connected my OTG cable, <u>not before</u> (first to RC then to Nvidia) and the bars were still there and i could even change frequencies/channels.</p><p>No clue why the Location button had an incidence on the Channel bars/frequency.</p></blockquote><p></p>
[QUOTE="Giantprawn60, post: 80847, member: 15632"] So i had this issue where i had no channel bars showing at all.Drone would fly fine though.It only said i was on 5.8ghz.Nothing else and i couldn't change it. I was using OTG or WIFI only and i had no channels showing in both cases.Well I found the fix in my case.I use a Nvidia Shield tablet. I had to untick the "location" icon in the notification bar at the top(i believe it's the same as the GPS icon on other devices). Then I power on the Spark, then RC. I connect the Nvidia to the RC through its wifi signal and open DJI Go 4. It connects. I go in the WIFI settings and waited about 5-10 secs.And voila, the channel bars appear!! I [U]then[/U] connected my OTG cable, [U]not before[/U] (first to RC then to Nvidia) and the bars were still there and i could even change frequencies/channels. No clue why the Location button had an incidence on the Channel bars/frequency. [/QUOTE]
Verification
Post reply
Forums
DJI Spark Forums
Spark Discussions
No channel bars???