Menu
Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Search
Search titles only
By:
Search titles only
By:
Menu
Welcome DJI Spark Pilot!
Jump in and join our free Spark community today!
Sign up
Forums
DJI Spark Forums
Spark Discussions
Questions using the OTG cable
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="JohnCC" data-source="post: 19366" data-attributes="member: 1139"><p>No, I don't wait for the mobile device to connect to the spark. Green light = spark bound = ready to go at that point, actually. However, I ensure wifi and bluetooth are turned off in the next step as an extra measure to remove any possible interference from them. I think this is a crucial part of getting the most out of your cabled connection. There is no reason to have either bluetooth or wifi enabled at all. <em>Especially</em> bluetooth, as it is known to reduce your range in general and should be disabled even if you aren't using the cable. So I added it as a step... even though you can technically skip step #3 and just plug in your cable to the spark RC.</p><p></p><p>I have mixed results regarding the app already being open before plugging in the cable for the first time. Your results might vary, of course. Also, I haven't upgraded to iOS 11 so I'm not sure if anything has changed.</p></blockquote><p></p>
[QUOTE="JohnCC, post: 19366, member: 1139"] No, I don't wait for the mobile device to connect to the spark. Green light = spark bound = ready to go at that point, actually. However, I ensure wifi and bluetooth are turned off in the next step as an extra measure to remove any possible interference from them. I think this is a crucial part of getting the most out of your cabled connection. There is no reason to have either bluetooth or wifi enabled at all. [I]Especially[/I] bluetooth, as it is known to reduce your range in general and should be disabled even if you aren't using the cable. So I added it as a step... even though you can technically skip step #3 and just plug in your cable to the spark RC. I have mixed results regarding the app already being open before plugging in the cable for the first time. Your results might vary, of course. Also, I haven't upgraded to iOS 11 so I'm not sure if anything has changed. [/QUOTE]
Verification
Post reply
Forums
DJI Spark Forums
Spark Discussions
Questions using the OTG cable