Recent content by Daniel Liew

Mine is also having weird hang ups when I start the app and "Go Fly". The status screen just hangs there for like half a minute and I can't close the window.

Heard this before too, and I usually hold it at least 3-4 ft above ground. Still I'd like to know what I've been doing wrong all this while to always fail calibration

I can't remember if I took off from the ground or the hard case. But definitely there were lots of metal around as it was an indoor stadium. Magnetic interference could cause a drone to fly away on its own? That's really scary!

Agreed... hopefully it's not hardware issue but rather user error... But could this be the reason why it went crazy flying indoors? I manually launched it to about 1 foot, and it was hovering for a short while before starting to fly towards the wall.

Couldn't remember the LED Color. Are you referring to GPS vs VPS mode? On the screen it said VPS only

I would say lighting was adequate. Funny things was, when I flew it higher, it was fine. Only when I was flying about 1 foot above ground it happened.

Thanks for the informative video! However, I find my compass calibration almost always fails. Maybe 8 out of 10 trials will fail. Nowadays I just depend on the auto detection and do not calibrate when there's no prompt.

I was using the remote controller. Didn't check the compass or IMU status as I've always calibrated only when prompted. Anyway compass calibration almost always fails on my drone, even when there's nothing metallic close by.

Something strange just happened. I was flying indoors in a stadium for the first time just now. No GPS, only VPS. I launched the spark up to about 1 foot above ground hoping that it'll hover . Suddenly it started going crazy and started flying away. Could this be due to the video positioning...

Just a normal SanDisk 64gb class 10

At first I switched it with another SD and the lag went away, then I formatted the problematic SD both on my pc then on the drone again, for good measure... :p

Finally found what's causing the otg video feed lag. It's my microsd card! I refreshed and factory reset everything I could think of, including the phone, but it was still happening. Finally I thought about the microsd which was the only thing I hadn't touched. I suspect the file system was...

Hi, would you by any chance know how to factory reset the RC?

What I usually do (although it takes more steps) is stop the RTH landing when it's almost my shoulder height, switch the flight mode to Gesture mode, hold my palm out under the drone and let it land.

Thank you so much sharing Dronason. Will try it out later.