Recent content by Kris Jacobs

My micro tap & die set and micro drill bits with pin vise came in yesterday. Last night I carefully measured and drilled two 1.2mm holes in the new part, 4.4mm between centers. This evening I'll run the M1.6 tap thru the holes to make some threads. New photos in the album...

I think I've go tit! I switched to red Hatchbox PLA - MUCH nicer than their blue ABS. Plus this is the red back Spark. ;) This is revision 3 - the camera roll motor press fits into the cup nice and snug! Updated photos in my album for this little project...

My rough draft print of the replacement part is very close - just printed another one at .1mm layer height instead of .2mm, solid fill instead of 30% fill, and slowed down the print speed. BTW, I'm printing on a highly modified & tweaked Monoprice Maker Select V2, using Hatchbox blue ABS. This...

You're welcome Mike. Yes, I'd recommend taking advantage of warranty service @ DJI.

Look at the picture in my album linked above, where I'm pushing aside the ribbon cable to see those two screws.

Rough Draft printed and added to album, you can see it here: https://photos.app.goo.gl/vvkaQCCRcdKmEoGA8 Looks promising - but I've had a couple of beers so it's time to have a couple more and play some video games. :)

Disassembly was straightforward, here's the broken "camera roll motor mount": https://photos.app.goo.gl/r7bNBY94NqVLr5Qg6 1st draft is printing now...

Hello everyone. I work in local government IT; I support most local law enforcement agencies. An officer brought me this DJI Spark the other day - the roll motor on the rear of the camera has popped out of what I call the "gimbal roll motor mount". It appears the camera roll motor simply...