Recent content by ron77584

mag interference or deviation is almost always the reason it goes Atti mode. I think the M.I. detected is probably false or only last a few seconds but when the drone flight software thinks it is experiencing to much interference it ignores the compass and GPS. I believe it even reboots GPS and...

we need to prevent atti mode somehow. I think changing the amount of magnetic interference allowed might work, but I'm not sure what parameter to change.

If your spark ever went into atti mode it was because it thought there is mag interference. I never crashed but almost lost it when it went atti for no apparent reason in high wind 1/4 mile away from me 400 ft altitude. the spark ignores its gps when it thinks there is mag interference when it...

My spark went into atti after compass interference warning at 385 ft in a place I have flown hundreds of times and then drifted with wind for 30 scds before back in gps mode. I believe I could prevent this from happening by increasing the amount of magnetic interference the spark will accept...

My spark also went into atti after compass interference warning at 385 ft in a place I have flown hundreds of times and then drifted for 30 scds before back in gps mode. I believe I could prevent this from happening by increasing the amount of magnetic interference the spark will accept before...

have you removed the battery, I put a label under battery with my FAA # and contact info

I used dji assistant to factory reset after reinstalling firmware and all is good now. lights are on now except when filming.

The front leds are never on except at startup. I have tried reinstalling firmware and downgrading firmware and still no lights in flight. The drone is only a month old and I dont know what to try next. I do know they are supposed to turn off while recording but that isnt the issue. any ideas?