I was flying manually 10 days ago near my house and suddenly the Spark went into ATTI mode. I began to navigate back manually when it regained GPS and used RTH to bring it home. Over the last 6 days I've been using Litchi quite a bit and noticed the gimbal going crazy in the footage of the general area where I lost GPS in the manual flight. Every time I run the mission the gimbal becomes highly erratic in that spot and finally yesterday the mission stopped one waypoint short and reported that it went into ATTI mode. This phenomenon is all happening in a radius of about 1000 feet. I studied the flight footage and looked over the Litchi logs of yesterday's bad flight and I can only think of perhaps satellite internet interference? It's all residential so I don't know what other transmissions could be taking place. No problem being connected via WiFi in that area as I get a good feed and have complete control. Needless to say, I'm not flying over that way any more and all my Litchi routes are going to be altered to avoid it as well. Was just curious if anyone else has encountered a trouble spot like this. Outside of that radius everything else has been flawless.
Joe
Joe