Menu
Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Search
Search titles only
By:
Search titles only
By:
Menu
Welcome DJI Spark Pilot!
Jump in and join our free Spark community today!
Sign up
Forums
General Forums
Firmware & Software Discussion
Battery firmware update failed - now what?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="T.Kauffman" data-source="post: 28454" data-attributes="member: 5981"><p>That's the process I used to install the drivers and it worked.</p><p></p><p>Sequence I followed - </p><p>1) install Assistant and drivers (I got prompted to install two unsigned drivers -and device manager shows the devices as active and functioning)</p><p>2) rebooted</p><p>3) (much later, at wifi hotspot) - installed usb cable on AC and powered it up with good battery</p><p>4) launched assistant</p><p>5) plugged usb cable into laptop</p><p></p><p>Tried shutting down assistant and restarting with cable attached to laptop - no change.</p><p></p><p>Just tried shutting down AC and assistant, starting assistant, and then starting AC - also no change.</p><p></p><p>When the AC plugs into the laptop both Vision (Interface 3) under libusb-win32 services and DJI USB Virtual COM (COM3) under Ports (COM & LPT) activate. I'm about to dump this entire mess on DJI tomorrow, as this is getting just over the top ridiculous.</p></blockquote><p></p>
[QUOTE="T.Kauffman, post: 28454, member: 5981"] That's the process I used to install the drivers and it worked. Sequence I followed - 1) install Assistant and drivers (I got prompted to install two unsigned drivers -and device manager shows the devices as active and functioning) 2) rebooted 3) (much later, at wifi hotspot) - installed usb cable on AC and powered it up with good battery 4) launched assistant 5) plugged usb cable into laptop Tried shutting down assistant and restarting with cable attached to laptop - no change. Just tried shutting down AC and assistant, starting assistant, and then starting AC - also no change. When the AC plugs into the laptop both Vision (Interface 3) under libusb-win32 services and DJI USB Virtual COM (COM3) under Ports (COM & LPT) activate. I'm about to dump this entire mess on DJI tomorrow, as this is getting just over the top ridiculous. [/QUOTE]
Verification
Post reply
Forums
General Forums
Firmware & Software Discussion
Battery firmware update failed - now what?