Menu
Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Search
Search titles only
By:
Search titles only
By:
Menu
Welcome DJI Spark Pilot!
Jump in and join our free Spark community today!
Sign up
Forums
General Forums
Firmware & Software Discussion
Litchi range vs DJI Go range
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="AirCam" data-source="post: 63843" data-attributes="member: 10393"><p>I use Litchi on multiple DJI drones and the signal strength it displays on the Spark is quite a bit lower than the signal strength displayed on the Phantom 4 Pro under similar conditions. That would make sense because the P4P has a LOT better radio and I would expect the best the Spark radio could do would be measurably less than the best the P4P can do. Even though the Spark is showing signal strength far less than 100%, it still streams the video just fine and responds to RC input with no problems. I like to see the connection percentage drop off that way because it geves me a lot better idea of when I am getting close to the limit of communication and control. I am always in FCC mode.</p></blockquote><p></p>
[QUOTE="AirCam, post: 63843, member: 10393"] I use Litchi on multiple DJI drones and the signal strength it displays on the Spark is quite a bit lower than the signal strength displayed on the Phantom 4 Pro under similar conditions. That would make sense because the P4P has a LOT better radio and I would expect the best the Spark radio could do would be measurably less than the best the P4P can do. Even though the Spark is showing signal strength far less than 100%, it still streams the video just fine and responds to RC input with no problems. I like to see the connection percentage drop off that way because it geves me a lot better idea of when I am getting close to the limit of communication and control. I am always in FCC mode. [/QUOTE]
Verification
Post reply
Forums
General Forums
Firmware & Software Discussion
Litchi range vs DJI Go range