Hi all, been flying for quite some time with my spark. But recently after I updated the new firmware for sphere mode i was so happy but when I try I keep failing. I try many time only manage to capture 3/42 and auto cancel and it keep saying what linking fault. Can anyone help me ?
Sphere mode problem.
- Thread starter skybladeus
- Start date
I have the same issue. I refreshed the firmware using DJI Assistant and managed to get it up to 8-9 images but then the gimbal overloads when it point down.
I have the same issue with any shots that require the gimbal to point downwards. I have to re-start the drone in order to use it properly again.
I attempted to ask DJI for help after much frustration they told me to send it in to be checked.
I have the same issue with any shots that require the gimbal to point downwards. I have to re-start the drone in order to use it properly again.
I attempted to ask DJI for help after much frustration they told me to send it in to be checked.
Virtual1
Well-Known Member
- Join
- Nov 19, 2017
- Messages
- 191
- Age
- 53
I've had my gimbal go into "overload" twice and in each case I had to power cycle the Spark to reset it. Landing did not help. I suppose it's a safety to prevent the gimbal from damaging itself, and considering the likely expense of fixing that I imagine I should be grateful for its abundance of caution, but it's still a tad annoying. It'd be nice if it would attempt a self-reset ~30 seconds after shutting down due to overload.
Similar threads
