Spark barometer error

[Jah]

Hi all, anybody here experiencing barometer error on their Spark? Mine always shows up during start up. It will display the main controller data error (in red notification) and when you check the overall status it says barometer error contact dji support if it persist after restart.
it will stay like that in about 2-3mins then the message will disappear and then you’re ready to fly. Everything will be in normal operation. But everytime you turn off the Spark and tried to power on again. Same message will show up and repeats the cycle. I have refreshed the latest FW several times, did IMU and compass calibrations with no errors many times. But when i restart the drone after calibration, same thing happen.
what seems to be the problem on my Spark? TIA.

 

[Spark 317]

I'm not sure about this but it's from 2017...

SPARK BAROMETER ERROR

hi... my spark sometimes got issue Barometer Error, after reset sometimes working sometimes barometer error notice show, i was calibrated imu , and notice still shows and not show... any pieces of advice? thanks

forum.dji.com

.

Similar posts are made about the Mavics too.

 

[Jah]

I'm not sure about this but it's from 2017...

SPARK BAROMETER ERROR

hi... my spark sometimes got issue Barometer Error, after reset sometimes working sometimes barometer error notice show, i was calibrated imu , and notice still shows and not show... any pieces of advice? thanks

forum.dji.com

.

Similar posts are made about the Mavics too.

Thank you for the link Spark 317. Unfortunately, my barometer issue is not caused by the cpu fan. The fan never stop working once you turned on the aircraft. But i think it has to do with the temperature. Because of the 2-3mins (sometimes 4mins) warm up before everything shows normal. It seems that it needs to get warmed up first. Idk. But it’s not the normal thing on a Spark. Also it’s already waisting at least 5mins of my flight time. And we all know that its battery is the only downside of the Spark.

 

[DameEdnaBrown]

Try re flashing drone firmware using dji assistant 2 on pc

 

[Jah]

Try re flashing drone firmware using dji assistant 2 on pc

Thanks for the tip. But... I Already did that (many times) still the same. Barometer error always show up during start up.