- Join
- May 3, 2019
- Messages
- 13
- Age
- 40
Very good morning all!
I'm new to the forum and also a newbie Spark Pilot, so long story short, I purchased my Spark about a week ago and decided to take it for a spin..... while trying to do a very stupid shot above a pool it hit a cascade feature and went to the bottom (on my first flight). So after been sitting on rice for about 4 days I decided to try it out, put a new battery in, turned it on and I'm getting a Battery Signal Error.
I want to fully take it apart and see if there is any sulfate in the boards to clean it out but there are 2 screws with a white glue on them preventing me to do it. Can anyone help me on how to remove this glue out so that I can open it up?
Thanks!
I'm new to the forum and also a newbie Spark Pilot, so long story short, I purchased my Spark about a week ago and decided to take it for a spin..... while trying to do a very stupid shot above a pool it hit a cascade feature and went to the bottom (on my first flight). So after been sitting on rice for about 4 days I decided to try it out, put a new battery in, turned it on and I'm getting a Battery Signal Error.
I want to fully take it apart and see if there is any sulfate in the boards to clean it out but there are 2 screws with a white glue on them preventing me to do it. Can anyone help me on how to remove this glue out so that I can open it up?
Thanks!