Recent content by texman1776

Dji spark goggles. There is a better way to hook transmitter goggles with self contained DVR screen, with super long range yagi antenna transmitter Antennas. That setup alone is cost prohibitive to the Spark if your just buying that setup for the Spark alone. However if your buying a...

I noticed with wire ribbons they are so fragile, and cheap I replace them everytime a component needs replacing. As for the gimble overload that could any number of things. To heavy of a lense filter, Camera movement is dragging on aftermarket shield. Calibration needs to performed. There's...

What is the best size, brand, etc, screen for the the UAV. Something not so big it's cumbersome, works best inn the sun. Best possible charge sustainability, best potential storage capability, Has the most adaptability with largest range of consumer aftermarket upgrades. I'm currently using...

I've been flying DJI SPARK drones for 6 months and haven't noticed battery problems. I had a hard landing after a drift landing put the drone in a tree, and noticed the gimble design has engineering protection flaws. But on the battery, from looking at the picture, I noticed two sized lock clip...

Named mine Simply CAT. Cat1, Cat2 so on. Depending on how many times they were Crashed before I bought them from someone before ressurected. Don't name ones I bought new Cat. HQ is hanger queen. HQ1 HQ2,

I have. only problem I found was the Compass hates it. The on board electronics

I found some really High End skins and crash skins on Amazon.

Not sure if the picture works. But I can draw a better sketch of DJI camera design with detailed information. I'm also quazi Artist. This build saves $200.00 + in repairs

Being in Photography 30 years, Drones, back when the only thing you could fly was micro 110 film rocket head. LOL I was putting Camera on Collective pitch Gassers a leaned a little about Rotor Bounce on Digital Cameras. Putting what I've learned from the past the bounce reminded me of a...

I figured it out. When Installing the Camera putting it back together, The Camera Circuit board has a Notch on it. The wires are traced down to the notch, wrapped back to the front on the lense side of the board. The tape on the harness fits to front side of the notch. The micro harness...

Hello New here I've been flying Drones I got s one extra range out of my spark by installing aftermarket Antenna poles, I've noticed some people requiring a HAM license to purchase some sparks and Mavs with upgraded telecom. I am a HAM operator And haven't research this yet. K5HRD

I'm looking for parts Drones. But at that point it's far less than new value.

I have replaced Gimble. Incerted Camera original screws etc The Camera has 4 possible ways to be re incerted, 12 O Clock, 3,6,9 O clock. there a notch on the Camera IC board and camera lenses side has 3 crystal on the face. And the lenses base has an offset lobed side. The printed side has...