hi wifi

[andreas]

hi i don,t have information on wifi settings..i connect the phone with rc with otg..and how i change 2.4 or 5.8

Sent from my SM-G955F using SparkPilots Spark Forum mobile app

 

[Dronason]

You cannot set it when you are connected with OTG cable. You need to start in wifi mode, set the band/channel and then connect the OTG cable.

 

[andreas]

and the information tab?i don't have informtion because i am connect with otg?

Sent from my SM-G955F using SparkPilots Spark Forum mobile app

 

[Dronason]

I think, ou should be able to see which band it uses, but I need to recheck. I assume you are on Android?

Sent from my SM-G950F using SparkPilots Spark Forum mobile app

 

[The Editor]

I wonder if this has been covered before........

 

[Dronason]

and the information tab?i don't have informtion because i am connect with otg?

Sent from my SM-G955F using SparkPilots Spark Forum mobile app

In the top bar, only here I see if it use 2.4./5.8G and it is correct.


In the "Image Transmission Settings*, I don't see right values, channels looks like for 2.4G. So this page is not correct and is useless.



OTG cable is not supported by DJI, this is why the trick of using it is far from being THE perfect.

Using OTG gives some limitation:

• Cannot change wifi band. In IOS, on android it don't seems correct (looks like PH3).
• No signal level indication.
• Loss of custom buttons setup (for ios devices only).
• Not officially supported by dji, so it could be removed.
• Some says that RC cannot be calibrated ? (not checked)
• RTH maximum altitude is 50m (not checked)
• Shows the Joystick/GUI button at bottom left (not checked)

 

[Dronason]

I wonder if this has been covered before........

Yes it has most probably been, if you know the perfect thread that answer the question, please post a link.