Strange warnings that disappear after a minute or two

[jleone15022]

So for the past few days, whenever I turn on my spark and connect to my controller and open the DJI Go 4 app, I get an IMU error and a firmware error message. Then they go away after about a minute or two. After that everything is cool again. Everything works just fine. I'm not really worried about it but I was curious to see if anyone else has a similar experience.

Sent from my LG-M430 using SparkPilots Spark Forum mobile app

 

[Dronason]

Never get that messages. I would be worried but if it fly ok.
Did you try some firmware refresh or factory reset with the DJI assistant 2?

 

[The Editor]

So for the past few days, whenever I turn on my spark and connect to my controller and open the DJI Go 4 app, I get an IMU error and a firmware error message. Then they go away after about a minute or two. After that everything is cool again. Everything works just fine. I'm not really worried about it but I was curious to see if anyone else has a similar experience.

Sent from my LG-M430 using SparkPilots Spark Forum mobile app

I would worry if I got an IMU error message and would personally ground any of my aircraft until I could determine the cause of the error.
But then I operate commercially and therfore don't just 'stick it in the air' if it seems alright. I have a comprehensive pre, during and post checklist which I follow and any error message during pre flight checks would mean the aircraft stays grounded until the issue is rectified.

 

[jleone15022]

Well the good news is after a quick refresh, all problems gone. All is back to normal.

Sent from my LG-M430 using SparkPilots Spark Forum mobile app

 

[Dronason]

Well the good news is after a quick refresh, all problems gone. All is back to normal.

Sent from my LG-M430 using SparkPilots Spark Forum mobile app

Good news