Hi all. I picked up a refurb spark about 2 months ago. Logged a few flights but from day one I lose signal to the bird.I used to think it was wifi interferance but I've switched channels all around with no luck as well.
I've always been on the latest firmware and IOS go4 app.I use an OTG cable pretty much every flight. I have noticed if I set the spark in flight mode with just my phone I have to rebind the remote. I've followed the start up procedure as I've read here. Spark, Remote, OTG into the phone then app. Strange thing is when I lose signal I seem to lose the recording on the card as well. When I see choppiness in the files on the phone I also see it in the card. Almost like the whole Spark is choking.
What could cause something like that? Bad or faulty unit? Can I find this somewhere in a log by chance from the Spark?
I've always been on the latest firmware and IOS go4 app.I use an OTG cable pretty much every flight. I have noticed if I set the spark in flight mode with just my phone I have to rebind the remote. I've followed the start up procedure as I've read here. Spark, Remote, OTG into the phone then app. Strange thing is when I lose signal I seem to lose the recording on the card as well. When I see choppiness in the files on the phone I also see it in the card. Almost like the whole Spark is choking.
What could cause something like that? Bad or faulty unit? Can I find this somewhere in a log by chance from the Spark?